QCI LS5T-37 El manual del propietario

FOR YOUR SAFETY READ AND UNDERSTAND THE ENTIRE MANUAL BEFORE OPERATING MACHINE MODLE NUMBER : □ LS5T-37 □ LS5T-52 SERIAL NUMBER :

9CAUSE PERMANT DAMAGE TO THE LOG SPLITTER. 17. Max Pressure Limiting Screw DO NOT ADJUST THE MAX PRESSURE LIMITING SCREW ! Max pressure w

10 LOG SPLITTER OPERATION

11 This log splitter is equipped with “ZHB” control system that requires to be operated by both hands of the user – Left hand controls the hydraulic

12on it to split excessively hard wood. After this time interval, the oil under pressure will be overheated and the machine could be damaged. For

13 Release both controls.  After the log pusher moves back and completely stops at its starting position, insert a wedge wood under the jammed lo

14Replace the Hydraulic oil in the log splitter after every 150 hours of use. Take following steps to replace it.  Make sure all moving parts stops

15• ARAL Vitam GF 22 • BP Energol HLP-HM 22 SHARPENING WEDGE After using the log splitters for some time, sharpen the wedge of the log splitter

16unfamiliar noise or vibrating a lot Air sealed in hydraulic system while operating. Loosen Bleed Screw by 3 ~ 4 rotations before operating the log

17PARTS SCHEMATIC (1)

18PARTS SCHEMATIC (2)

1TABLE OF CONTENTS CONTENTS PAGE Safety Warnings & Cautions 2-4 Application Conditions 4 Specifications 5 Electrical Requirements 5 Conten

2SAFETY WARNINGS & CAUTIONS SYMBOL AFFIXED TO THE MACHINE SAFETY WARNINGS & INSTRUCTIONS  UNDERSTAND YOUR LOG SPLITTER Read and understand

3resistant lenses. They are not safety glasses. Do not put the log splitter on the ground for operations. This is awkward operating position that the

4protective hair covering to contain long hair, preventing it from get caught in machinery.  DON’T OVERREACH Floor must not be slippery. Keep prop

5  MAINTAIN YOUR LOG SPLITTER WITH CARE Keep the log splitter clean for best and safest performance.  MAKE THE WORKSHOP CHILDPROOF Lock the shop.

6APPLICATION CONDITIONS This log splitter is a home use model. It is designed for operating under ambient temperatures between +5oC and 40oC and for

7 Connect the main leads to a standard 230V+10% (50Hz+1Hz) electrical supply which has protection devices of under-voltage, over-voltage, over-curren

81. Oil Tank 2. Log Pusher 3. Work Table 4. Wedge 5. Lift Handle 6. Support Leg 7. Work Table Extension w/ Log Retaining Plates 8. Switch 9. Motor 1